Hi all, just after a bit of advice.
I have a GT and a surf board, i usually recline the front seat and it slips in nicely from the rear tailgate. Anyway, i now have borrowed my mates long board and this method is now not possible by about 6inches oh come on......
So after calculations, ie (thinking) i reckon if i take out the passenger front seat the fins will go in the foot area and the rear seats can fold down and it might just fit.
Which poses the question, can i electrically disconnect the seat with no problems?? i can figure out how to remove the seat rails, there are 4 lage bolts and then lift it out, but i'm unsure on the result of disconnecting the seat to the 'brain' on the car.
If anyone out there has any advice it would be greatly appreciated.
If you remove either of the front seats then the airbag light will come on, it may or may not turn off when you reconnect the plug but if not you'll need it clearing with FiatECUScan or a trip to the dealers. The seats them selves are very easy to remove however, 4 allen bolts iirc.
thanks for the info chaps, i had a sneaky suspicion it might set of the air bag light, but I'm not paying for it to be cleared, so i think i'll use my old board and not take out the seat.
re, sticking it out the window, its too wide. thanks though.