selespeed problem error code p0715
I have a 2000 156 2.0 selespeed and the selespeed warning light came on and went into limp mode (only 1st and 2nd gear).
plugged in alfadiag and there was a error. I reset alfadiag errors as was not sure how old these were and started again.
Car was fine for about 3-4 miles then warning light was bleeping and flashing in only in 1st then moments later came on fully and went into limp mode again. got it home and plugged in alfadiag error P0715: Clutch Speed.
full description below:
Failed Component Code: Clutch Speed
Fault Symptom: No Signal
Warning Lamp Status: Warning Lamp Illuminated
Fault Test State: Test complete for this Error or not applicable.
Fault Code Storage State: Error Present at time of request
Event Count: 64 count
Environmental Condition One: Time Error Present: 6 minutes
Environmental Condition Two: Engine Speed : 864 rpm
Environmental Condition Three: Vehicle Speed: 7.05 km/h
Environmental Condition Four: Gearbox Oil Temp: 32 °C
Environmental Condition Five: Requested Gear: First
Environmental Condition Five: Inserted Gear: Second
Environmental Condition Six: Battery Voltage: 13.485 volts
I now have only 1st & 2nd gear, when i clear the code, car is fine until i come to a stop, and all starts again.
Ahhhhhh Can any one help with this codes etc. ???
Hope this not going to cost to much..