Crank sensor query?
Had a problem yesterday when car wouldn't start when warm, left the car overnight and borrowed a code reader. Went to car this morning, fired up as normal but left on management light so plugged in reader and got P0335 crank sensor as a fault which I cleared and drove car home.
Picked up a new sensor and fitted it (what a ***** of a job to get to!!!!!!)
Fired up again no problem and test drove fine but found when I blip throttle to 4K revs it brings the light back on again and when you read the code it comes up with p0336 but now says "position - range" reset the code and off goes the light.
I presumed it must be loosing signal at higher revs so took it out and made sure it was seated properly and fitted again but still get the fault. Any ideas what may be causing the problem, new sensor duff of I have missed something
Any help appreiciated
Last edited by IanG1; 09-05-10 at 18:27.