hi all have not been on for a few days, due to other half been in hospital for heart opp.
but she,s ok now so time to get back to car.
first of all i tried new batt with no success, but worth ago
then i removed actuator & selected all gears by hand & all was fine, as far as i could tell not tight in any way to be honest.
so i moved on to actuator. i removed range sensor but when i removed screws the sensor spun round anti clock wise about 10 degrees,i dont no if this is meant or not.
after this i moved the selector inside the actuator to see if the peg that goes in to sensor move while doing this. it did but very little, did not even move the selector half of an inch up the way and heard a small ping.
should this peg return to where it was. after i move the selector in actuator & return it back to the same position.
does anyone know is the back plate easy to come of to have a check of this peg as i am sure i have a probs in there.