Selespeed: Car's gone mental!!!
Ok probably one for iainfm or smaky.
Yesterday I noticed a leak coming from the bottom of the car, looks like its coming out of the Actuator but need to get the battery out to have a look. Its dripping onto the drive shaft and thus spraying everywhere.
Checked the sele res and it was next to empty i.e. could only see the bottom silver plate thing. Topped it up to max and took it for a spin, its lost a wee bit but it has come back milky as if air is getting into the system. Pump is running every 2 gear changes so system is not holding pressure.
Also hooked it up to Alfadiag this morning and the clutch actuator rod position is sitting at 17.12mm. When I started the car it dived to 7mm. Upon further inspection you can see the clutch rod is a at a funny angle indicative with a 7mm position.
Quite sure there is a leak, but with the clutch position being so far out whether is just a leak or something has gone wrong and pierced something?
Bizarre thing? The car runs and selects gears fine, no problems whatsoever. Although at one point it did flash in 2nd gear.
Ta for your help going to start on the clutch position and a basic inspect.