2.4 JTD error code - overboost and VDC error on MAR
ok 2 problems
Just got alfa diag and cleared all errors in the ecu to be sure i was only reading current stuff
cleared codes and car went like s*** off a shovel - i am not sure if this thing has already been remapped or not...
anyway on hard accel in 3rd at about 3k rpm got engine management light flash up for a second motor control failure and acceleration died. let off throttle and then it accelerated again but felt way more ponderous
got 2 error codes
p0380 - dodgy glow plug - don't care - unless its minus 14 it'll be fine
p0235 - this one concerned me turbo system overboost
I am also getting VDC system fail on MAR straight away before engine start.
I had the same thing on my seat leon cupra 1.8t and that was a failed maf sensor which took the traction control offline immediately - was thinking along the same lines with this one hopefully.
I was getting VDC errors on and off as usual in the cold weather but since i reset the ecu it's now on from start.
any ideas guys? Am i along the right lines?