oki.. went to mechanic school where my friend is, and tryed to fix my self..
connected pc showed-
P1653 phase variator : short circut to ground
P0443 Evaporation control valve ; short circut to GND
P1654 Modular manifold control; short circut to ground
so we fought, that this might be some electronic problem, computer was showing -30 engine temperature.....
So, we checkec ECU plugs, teperature sensor, maf sensor , cam sensor voltage thing.... and found out.. that maf is not getting no electricy, and few other sensors are not getting it to..
so the mechanic took the maf plug, put in a needle near the red cable, put it to battery directly, i started car... and it showed 1.5 rpm, working good, sounds like all cilinders are working and so on... diagnostic pc showed no error....
Oh by the way- my cilinders where fith petrol-oil ... but compression was 14-11-11-14 ~ is this normal?
So, what advice can you give? should we just make a wire with erm ... you know ... protector thing
directly to battery.... or maby some one could just point out the missing thing? AGAIN- ALL ERRORS DISAPERED AFTER CONNECTING DIRECTLY,BUT INJECTION LIGHT WAS ON, BUT CAR RAN ALLMOST NORmal.