Banned for not
following the site
Join Date: Feb 2008
Location: United Kingdom
Is the problem with selecting gears or starting the engine?
Those readings all say the system is fine so the problem is most likely the gearbox, but it could still be the filter on the pressure port of the actuator being blocked. You'd need to watch the pressure of the syatem as the gears are selected, if it drops down below 20Bar then you have a blockage (normally that filter) and if the gears are tight it will struggle to hit them and just bin to the previous or the one above depending on speed.
Also the EOL calibration willpass and all the other readings will be acceptable if the speed sensor (part # 55212289 £50) is faulty, this would also tie in with your other thread which mentioned the grey colour of the sensor.