step by step?
I removed all the bolts from the bottom runners first
removed the main fuel pipe from the fuel rails
Bleed the fuel out
Undone all the bolts on the runners
removed the 2 bolts from the bottom rail and pulled off the injectors slowly
Uncliped the tops and pulled out the 2,4,6 runners
removed the 2 bolts from the top rail and pulled off it off the injectors slowly
Uncliped the tops and pulled out the 1,3,5 runners
Removed the runner gaskets
Removed the 6 main bolts on the bottom plate
removed the 6 main bolts on the top plate
Removed the gaskets from them.
Pulled out the 2.5 injectors and installed them into the 3.0 Plates.
Fitted new gaskets and used a light gasket sealent on the 3.0 plates
Pushed them on and bolts them lightly then tighted them up(done the same with the both plates)
put gasket sealent on the plate tops to hold the runner gaskets in place
Refitted the back fuel rail and installed runners 1.3.5
installed runners 2,4,6 and installed the frout rail.
pushed the rubbers over the top tightly and claped them up.
Reconnected the injectors, and left the battery off to do a reset.
Started it to check for leak and she didn't start.
i didnt remove no air pipes
For some odd reason pug sent me 2x 3liter injectors.. which i didn't use. i was ment to use my own right ????