156 Selespeed nightmare Help
Help!! can some one give me an idea why my alfas playing up?????
here is the story, i bought a 156 selespeed about a month ago, drove fine just had 1 problem.... which i wish i left alone!!!!
On change down 3rd to 2nd and 2nd to 1st i got a glunk each time only in the lower range, after getting advice from the forum regarding this I took to my local alfa guru, he did a selespeed calibration and ajusted my clutch pin/rod 3-4mm, I paid my bill and was on my way.....
The clunk was still there but was told they do this by the alfa guru, Now every now and then the geabox light comes on after a drive and I lose all selection it's as if the system has shut down... after much scratching and an hr on the phone to the guru i was prepared to tow it to him, jumped in car and all was ok?????
The day after it happened again when i went on a job.. parked up finished my job about an hr later jumped in to go home and gearbox light on again????
This time i relayed to the guru only for it to be fine at his garage when it arrived????
He stuck on the computer no faults found???? Took it away and the day later did it again light came on this time i left for about 4hrs and it was fine again????
Took it back to the Alfa garage no faults found did a selespeed calabration again took 2 attemps but compleated fine rod was correct length so the computer said??? HELP PLEASE Someone must know what the XXXX's wrong with it???? it's drivin me mad..