Hi, I have a 2002 147 2l Selespeed and have been advised to get Alfadiag.
Before I get into it, I have sent the car to Alfa Service Center in Edenvale at the beginning of March. Was not able to select any gears.
The car was working perfectly when I got it back, but then alas some time later I had to take it back in. It seemed to be bunny hopping on take-off, reving high and then engaging the gear like when the clutch slips. Above all of this it just seems that the car has now lost alot of power.
The sphere has been replaced with a bmw part and I think that these problems are being caused by it not being ale to hold the required pressure. I have been advised to buy alfadiag and bleed the clutch and do recalibration on the selespeed.
I have looked on alfadiag.net and do not see the 147 Selespeed listed. I do not have a owners manual for the car and dont know the ecu type in order to determine if it supported by alfadiag also does it matter which interface I get? I would prefer the usb.
USB ISO OBD-II / VAGCOM / AlfaDiag KKL Interface or RS232 ISO OBD-II / VAGCOM / AlfaDiag KKL Interface
Any suggestions or comments are aprreciated.
Last edited by nelesh; 14-04-09 at 09:49.