Re: Rear trailing arm to hub bush q??
I did this at the weekend and I used the new ones that came in with the powerflex kit. Was a good bit of hassle cutting the 1st one out, but once I learned the "knack" on one side it was much easier to do the other side.
My old ones were quite rusty.. dunno if leaving them in would have made a difference. The inside of the shell needs to be copper-greased beforehand so I reckoned a clean, new surface here would be better. Anyway, I would have felt guilty not putting the shiney new ones in, though I have no idea if it made a difference!
As somebody already said the "fit" might be different but that is easy enough to check.
Last edited by GavinH; 18-03-09 at 20:37.