Re: 147 selespeed mucho aggrivato
yes it does...when the fault was cleared by the guy at the garage,it would engage all gears with the engine off,ignition on.
only 1,2,r,n with the ign on.
It wont do it though when the fault is present..
garage guy put his snap on gizmo programmer on and reset the fault.when car running fault returns.
fault code is PO715 clutch disc speed signal.sensor at gearbox is good.
QUESTION///.the screened cable that runs via the connector block ,that takes the signal from the clutch speed sensor to the ecu.
should I get continuity from pin 18 to other end .the yellow one.
continuity is ok from pin19.
why is this cable heavily screened,and can I run a normal wire to prove this part..
can I get one, or do I need the full loom.
Last edited by aggrivato; 06-01-09 at 15:56.