156 Airflow Meter Error code Alfadiag
After replacing the head and doing an ECU reset my fault light is on and I am getting the error code from alfadiag as follows. Does anyone know what the - below minimum limit means. I wondered if this appeared until the ECU learnt it's settings after the reset? If I clear the error it immediatley appears again.
Error code P0100
Failed Component Code: Air Flow Meter
Fault Symptom: Below Minimum Limit
Warning Lamp Status: Warning Lamp Illuminated
Fault Test State: Test not complete for this Error.
Fault Code Storage State: Error Present at time of request
Event Count: 40 count
Environmental Condition One: Engine Speed: 960 rpm
Environmental Condition Two: Relative Load: 26.25 %
Environmental Condition Three: Engine Coolant Temp: 60.75 °C
Environmental Condition Four: Air Temp: 39 °C
Environmental Condition Five: Throttle Valve Angle: 0 °
Thanks for any help !