ok, finally got my sele hooked up to alfadiag today, had a good "poke around".
read ecu error codes from the main ecu, got one, PO115, engine temp sensor no signal. it told me there should be a warning light on, but there isnt.
is this an easy fix? im assuming no signal means it has failed.
i also did an actuator test on my injectors, injector 3 failed but injector 5 works??
also the air mass meter voltage fluctuated a bit, constantly up and down a tiny bit between 1581mV and 1526mV. injection time also slightly unsteady, should these two "hold" a certain figure while the engine is running?
the good bit: i went through the recalibration procedure on the sele's ecu, and it now changes just that little bit smoother, and that little bit faster, and i also have reverse gear direct from neutral! :cheers:
only problem was, it failed bleeding the clutch, the ecu disconnected for some reason. no probems though, just refused to do it.