156 1.8 TS -97 gearbox removal
I need some advice from anyone done this before:
Tomorrow I am going to get my gearbox out to fix an oil leak. Also replacing the clutch, release bearing and slave cylinder since I have these already in my garage!
But, I think I read earlier something about that it`s extremely important to add some sealant on a specific place to avoid leak, resulting in a complete tear-down again.. Anyone did this before, and know exactly where that spot is? Think the spot was not 100% obvious, so it was a risk to get a leak. Second, are there any special things to be aware of, or is this a straight forward job? Any ideas/comments are much appreciated! Thanks in advance!