Android Torque not clearing MCSF - Alfa Romeo Forum
You are currently unregistered, register for more features.    
Thread Tools
(Post Link) post #1 of 1 Old 12-07-16 Thread Starter
Status: New quiet lifters
AO Silver Member
halftone's Avatar
Join Date: Feb 2012
Location: United Kingdom
County: Greater London
Posts: 1,326

Member car:

147 Sport Q2

Android Torque not clearing MCSF

This is the pro- version of Torque, car is 2008 147 Sport Q2 (150bhp 1.9 JTDM 16v) with Bosch EDC16C39 ECU.

Trying to check the source of my tappety-sounding cold idle, I pulled the connector off the injector on cyl #3. As expected the rattle vanished, which confirmed what I thought - that injector is in need of attention. Previous MES has shown correction factors on that injector to be excessive. I also pulled #4, which also has slightly excessive correction, but that made no change to the noise.

Still, as expected disconnecting the injectors logged fault codes, which I then cleared with Torque, apparently successfully since re-reading codes show none present. However the MCSF light is still on.

This is the second time Torque has claimed to clear codes but not done it correctly or as fully as MES (reg) does (which works 100% fine except for a reported fault on a wiper washer relay on a car without wiper washers. Does anyone else see this with Torque?
halftone is offline  

Go Back   Alfa Romeo Forum > Supported Alfa Romeo Models > Technical & Vehicle Assistance > Alfa 147, 156 & GT

android , clearing , mcsf , torque

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Replace with
For the best viewing experience please update your browser to Google Chrome