I find it hard trying to turn the 2 screws on the center panel with a book.

But feel free to try following the below guide.
Wheels off,
5 screws for each arch inside cover (you can just undo the front 2 and prise it out the way enough though),
6 screws for the front trim panels under the bonnet,
14 screws to hold the bumper on ( 3 under front end, 4 on top of the front end, 3 inside at the top right, 1 lower right, 2 inside at top left, 1 lower left),
Pull bumper away slightly,
Disconnect light washer hose connection and fog light loom plug (if equipment is fitted).