Banned for not
following the site
Join Date: Feb 2008
Location: United Kingdom
Re: The bonnet alarm sensor
Yes it is and it's probably so covered in rust that it's shorting out and signalling that the bonnets shut all the time, the alarm though can have the auto set feature turned off and also the arming beeps too, USA is the best option.
- Open the bonnet
- Turn ignition key from MAR to STOP.
Within 15 seconds of this, the bonnet switch must be pressed 7 times in less than 10 seconds.
- 5 beeps will indicate entry into manual diagnosis mode. During these 5 beeps press the switch once again, a long beep will signify entry into country code programming mode. Keep the switch pressed throughout the duration of the long beep.
- Release the switch and then press it (within 10 seconds) the number of times to correspond to the country code required (see below). Each press will be acknowledged with a beep.
Last edited by Smaky; 02-08-08 at 10:44.